Boiler size：100,000 to 6 million kcal/hour (120KW to 7000kW)

Fuel：oil, gas

Uses： lt can be used as a high-temperature heat source at various temperatures below 350 ° C, and is widely used in various walks of life that neeohigh-temperature heating or drying; High temperature and low pressure; Precise temperature control and high utlization rate of thermal energy. And optionasteam generator to produce saturated steam below 1.3MPa for user use.

Key Features:

1.The design, manufacture and inspection of products are strictly implemented inaccordance with the "Organic Heat Carrier Furnace Safety Technical SupervisionRegulations"，"Hot Water Boiler Safety Technical Supervision Regulations"GB/T17410-1998"Organic Heat Carrier Furnace" standards and regulations, andare inspected by the national special equipment safety supervision agency. safe andreliable.

2.The heating surface of the boiler adopts gas shielded welding full penetrationwelding, and is qualified by X-ray flaw detection and hydrostatic test to ensure thatthe welding quality is higher than the national standard.

3.The diameter and length of the radiant coil are fully adapted to the flame of thematching burner to ensure the reliable work and sufficient cooling of the coil.

4.The convection heating surface adopts a high and reasonable flue gas flow rateon the basis of rigorous calculation to ensure the full heat exchange of the furnacebody and ensure the high thermal efficiency of the boiler system.

5. The boiler body adopts reasonable structural design and high-quality refractoryand thermal insulation materials, so that the external surface temperature of thefurnace is W 50 ° C, which is higher than the national standard requirements.

6. The boiler body is assembled and shipped from the factory, and the combustionsystem, pipeline system and electronic control system can be installed after the useris in place on site, which has the remarkable characteristics of relatively shortinstallation cycle and low cost.

Security protection functions andmain control points:

1.Heat transfer oil outlet temperature display: can be displayedon site and far transmitted to the control cabinet through theinstrument display, the user can set this temperature value. andcan be interlocked with the induced draft fan to achieveautomatic adjustent operation, and high temperature alarm.

2.Heat transfer oil inlet temperature display: can be displayedon site and remotely transmitted to the control cabinet byinstrument display.

3. Heat transfer oil outlet pressure display: can be displayed onsite and remotely transmitted to the control cabinet by instrumentdisplay, and overpressure alarm can be realized

4.Heat transfer oil inlet pressure display: can be displayed onsite and remotely transmitted to the control cabinet by instrumentdisplay.

5.Expansion tank level control: realize the low level alarm of theexpansion tank, timely remind the stoker personnel to fill thesystem with oil, and ensure the safe and reliable operation of theboiler system.

6.Adopt imported burners of international famous brands.reliable quality and trustworthy.

Technical parameters of oil (gas) organic heat carrier furnace

Note: The data listed in the table is for reference only, and the drawings provided are subject to the random drawings.